High Performance MaxLife® Coated Up and Down Cut Spirals
High Performance MaxLife® Coated Up and Down Cut Spirals
An up spiral will clear chips most effectively from non-through cuts and will reduce chip-out on the uppermost surface of the work for through-cut
A down spiral bit will minimize chip-out on the lowermost surface.
Coated tooling: coatings further extends tool life by reducing damaging effects of heat and oxidation that occurs during cutting operations. Highly recommended for MDF, chipboard with melamine, laminates, veneered plywood, and many plastics
- MaxLife® coating is a micro-thin ceramic coating which enables the tool's cutting edge to retain crucial sharpness and lubricity. This provides longevity and produces cutting results of the highest quality.
- Coating prevents high heat and oxidation which is detrimental to cutting tool performance.
-
MaxLife® offers approximately 5,000 Vickers for impressive solid hardness on cutting areas of the tool, for an increase up to 5 times compared to uncoated bits.
